DIUDUS Type C Manual Leather Splitter

CHOOSE THE TOOL FOR YOUR WORK

Choose a feed-and-adjust mechanism for narrow pieces

The Type C is a useful comparison when you want to move from freehand paring to a hand-fed thinning mechanism. You pull the leather through the tool yourself, while screws on both sides adjust the thinning setting. That separates it from the Mudder handheld skivers and from the WUTA strip cutter, whose main job is cutting strap width rather than reducing thickness.

The stainless-steel tool comes with ten blades, four screws, two L-keys and an instruction manual. The spare blades extend the supplied blade stock for this one thinning tool. The seller rules out leather wider than 8 cm (3.15 in), so check the widest part you need to pass through, not just the finished width of a strap. Vegetable-tanned and chrome-tanned leather are named as intended material types, but material firmness still matters.

The seller says very hard leather is difficult to handle and overly soft leather is also difficult to operate. Its statement that softer leather can be thinned to 1 mm is a material-dependent example, not a promise for every piece or a calibrated adjustment resolution. That distinction matters if you need a repeatable finished thickness for a specific construction. Compare a handheld skiver for local edge work, and use the supplied setup instructions to understand this machine’s feed and adjustment before deciding it matches your material.